assembly instructions

No nails, screws, hammers, or drills needed.

Read and watch ALL directions first, then get after it!

step 1

Calibrate mounting tool:

Set the tool on a level surface. Slide cover until bubble is completely hidden.

step 2

Prepare mounting tabs:

Grab your mounting tabs and adhesive strips. Remove the red liner of the adhesive strip. Attach an adhesive strip to the flat side of each mounting tab, pressing firmly for 5+ seconds.

Clean the wall before hanging your Pelemento.

step 3

Prepare wall:

For optimal hanging, be sure you have a clean wall. Determine exactly where the Pelemento will hang. Make guideline marks to indicate the top and side borders. (We like to use painter's tape.)

step 4

Place first mounting tab:

Insert a mounting tab into Position A (A for Anchor Point). Remove adhesive backer. Using your guideline marks, lightly place the tool in the upper left corner. Check level, then press firmly against the wall for 5+ seconds. Pop the tool off mounting tab. This is now your first anchor point.

step 5

Place mounting tabs:

Insert mounting tab into Position 1. Remove adhesive backer. Click mounting tool on to the first anchor point, hold lightly against the wall, and check level. Then, firmly press against the wall, 5+ seconds. Pop tool off mounting tab. This becomes your new Anchor Point.

step 6

Continue:

Insert a mounting tab into Position 2. Remove adhesive backer. Click mounting tool on to the last Anchor Point. Hold lightly against the wall, check level, then press firmly to attach to wall. Continue along until you get to the last mounting tab--reserve one tab for Step 7.

step 7

Attach final mounting tab:

Insert the final mounting tab into Position 1. Click mounting tool on to the last Anchor Point. Mount just like before.

step 8

Add clips:

Slide corner clips and edge clips on to each mounting tab across the top. Corner clips on the corners, edge clips in the middle. Slide to adjust clips as needed when hanging the Pelemento.

step 9

Hang base tiles:

Starting with the top row, hang base tiles, clicking the tiles under the locking ledge of the edge clips. Continue hanging base tiles, using edge clips to connect the tiles on the edges, tile clips to connect the inner tiles, and corner clips for the bottom corners. Remember corner and edge clips along the bottom too!

Pro Tip